5/30/2023 0 Comments Bullet mould .501I'm also looking for a cheap source for pure lead being I have 40 pounds of linotype now? 501? I mean using a super slick lube like the mink oil? Yeah you know where I'm going with this, would you think I'd be able to do a single step sizing from. 515 diameter so they would be pretty hard to stuff down my muzzle loader's barrel being I can feel a difference between. My other mould I have yet to try is a Lyman 515141 I've read casts to about. ![]() My next tid bit I wasn't able to dig up much on the net about other than a few posts saying it is possible but with my experience so far sizing bullets I thought it best to say. ![]() I followed directions with everything and my lead isn't super hard although I did water drop them in very cold water. ![]() The strangest thing is the mold these bullets were cast in is the LEE 500-360M that ennded up casting bullets with a. When I swapped over to mink oil for sizing bullets everything went smooth as sink. I don't think that will happen again, it's now through bolted with drilled metal retaining plates for more surface area strength, the 3" by 1/4" lags just ended up working loose I guess. The sixth or seventh bullet out of two sizing sessions jammed up big time and I ended up ripping my press off my bench. ![]() sizing die and things went south pretty quickly. Would there be any issues with using shoe polish for bullet lube? I tried the Liquid Alox for my. I've just started to cast bullets for my muzzle loader being the expense of taylor mades so there is a bunch I have yet to learn.
0 Comments
Leave a Reply. |